-
- WI 388, February 2020
- Air Strike! | Interview with Andy Chambers
- Air Strike!
- 40mm 18th Century
- 32mm Fallout: Institute Core Box
- 32mm Judge Dredd Miniatures Wave 2
- 28mm Sci-Fi French: Les Grognards
- 28mm Medieval Scots and Conquistador Zombies
- New War Of Triple Alliance Range From Perry Mins
- 28mm Goblin Wolf Riders
- Wargamer’s Guide To Making Tabletop Terrain: Tales of a Wargames Widow Vol. 3
- Forgotten World
- 28mm Cinematic Samurai Heroes
- 28mm Vietnam War
- 20mm Wasteland Warriors
- 28mm World War Two Women
- Blood & Rust: High Octane Gaming
- THE WAR OF THE TRIPLE ALLIANCE
- WI 387, January 2020
- French Napoleonic Infantry Battalion and Elite Companies
I have answered my own question. After reloading new cartridge the printer had set to ‘colour’. When I changed it to monochrome sails printed fine – might help another IT novice…..
Hey folks at WI: I can’t get these to print out properly. I have a nice, neat stack of paper sails, none of which align back-to-front. Some are way too big. Help! What are the exact printer instructions used to get them to print properly, please?
Hi. I’m having the same issue as Matt above. What scale are we supposed to print these at? Because as given they’re far too big.
I’ve found that printing them “Flipped on the short edge” works. Size wise shrinking them to 80% seems to get the to roughly the correct size.
I can print and have tried three different settings. The sails’ names’ are fine, the scale is fie, but the sails themselves are not complete. My printer is otherwise functioning normally. Any suggestions?